The HPE4650 fill enclosure fills one cylinder for the single or two for the double at a time. The enclosure provides increased safety during the fill process, only operating when the door is closed and locked. The HPE4650 is designed to contain the destructive force of an accidental cylinder failure or hose rupture while allowing the energy blast to be vented away from the operator.
Construction:
- Exterior Cabinet Contains ¼” Steel Plate On All Four Sides
- Drawer Contains ½” Steel Plate Construction & ¼” Steel on Three Sides of the Cabinet, Result is ½” Steel On All Four Sides
- 6 mil Zinc-Rich Primer & Powder Coat
- Vented Through Rear Bottom of Cabinet
- All Control Components Located Inside Cabinet
- All Components are Brass or Stainless Steel and Oxygen Cleaned
Oxygen Cleaning:
Hypres Equipment oxygen cleaning process follows the recommended practices for oxygen cleaning, published in the Compressed Gas Association document, CGA G-4.1 and American Society for Testing and Materials document, ASTM G 127.
Hypres Equipment oxygen cleaning procedure follows the recommendations published in the American Society for Testing and Materials document, ASTM G 88 and ASTM pamphlet, Design Strategies for Polymer – Lined Flex Hose Distance / Volume Pieces.
HPE 4650 Single Fill Station | HPE 4650 Double Fill Station | General Details
HPE 4650 Single
Dimensions:
24.5”W x 26.5”D x 48.25”H, Approx. 600lbs
Standard Features:
- Teflon Slides To Protect Cylinder from Scuffing
- (1) Connection for Cascade System
- (1) Oxygen Clean Fill Hose w/Medical Yoke & Bleed Valve
- (1) Panel Valves to Control Fill Process
- (1) Fill Gauges to Monitor Fill Process
- Flow Fuse to keep fill rate at 300psi/min
- Relief Valve set at 10% above your fill pressure of 1850 psi
- 90˚ Door Opening to Horizontal
- Rear External fitting for your bench gauge
Safety Features:
- NFPA 1901-71, 23.9.1-4 Compliant
- Certified By A Licensed Engineering Testing Facility
- Tested to Contain Rupture of an 88 Cubic Ft. Cylinder at 4500 PSI
- Carriage Tilt Design Minimizing Operator Fatigue
- Safety Interlock Control System Preventing Operation Unless the Front Access Door is Completely Closed and Locked in Place
HPE 4650 Single Fill Station | HPE 4650 Double Fill Station | General Details
HPE 4650 Double
Dimensions:
33.5”W x 26.5”D x 48.25”H, Approx. 700lbs
Standard Features
- Teflon Slides To Protect Cylinder from Scuffing
- (1) Connection for Cascade System
- (2) Oxygen Clean Fill Hoses w/Medical Yoke & Bleed Valve
- (2) Panel Valves to Control Fill Process
- (2) Fill Gauges to Monitor Fill Process
- Flow Fuse to keep fill rate at 300psi/min
- Relief Valve set at 10% above your fill pressure of 1850 psi
- 90˚ Door Opening to Horizontal
- Rear External fitting for your bench gauge
Safety Features:
- Carriage Tilt Design Minimizing Operator Fatigue
- Safety Interlock Control System Preventing Operation Unless the Front Access Door is Completely Closed and Locked in Place
HPE 4650 Single Fill Station | HPE 4650 Double Fill Station | General Details